Installation Instructions

Test Equipment and LMF Connection

DEC 2000

7-7

SCt300 BTS Hardware Installation, ATP and FRU Procedures

PRELIMINARY

Overview

This procedure gives instructions to connect the LMF to the BTS.

LMF to BTS Connection

The LMF is connected to the MMI/LMF connector on the diagnostic

access area. The illustration (Figure 7-7) shows the connections between

the LMF and BTS.

The LMF serial port, or PCMCIA (Personal Computer Memory Card

International Association) Serial Adapter provides the connection

between the LMF and the MMI/LMF connector located on the

diagnostic access area.

Procedure

Connect the LMF to the BTS. Refer to Figure 7-7, Figure 7-8, and

Table 7-2.

Figure 7-7: BTS to LMF connection

DB9

LMF

CONNECT 15 TO 9–PIN

MMI/LMF CONNECTOR

TO MMI/LMF PORT

DB9 TO DB9

CABLE

CONNECT TO

PCMCIA SERIAL I/O

OR SERIAL I/O PORT

0183–O_IL.DOC