Installation Instructions

BTS Preparation

PRELIMINARY

SCt300 BTS Hardware Installation, ATP and FRU Procedures

DEC 2000

7-2

Overview

The purpose of this procedure is to prepare the BTS for the ATP. This

procedure consists of:

1. Solar Cover Removal

2. BTS Power Up

3. Diagnostic Access Cover Removal

Tools Required

The following tools and materials are necessary to do this procedure:

S Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M

S T20 Torx tamper bit

Remove Solar Cover

If you did not mount the solar cover during the unit installation, then this

procedure is not necessary.

Procedure

Remove the four captive screws (two on each side) that hold the front

solar cover. Refer to Figure 7-1.

Figure 7-1: Front Solar Cover (MicroCell Illustrated)

FRONT COVER

CAPTIVE SCREWS

BTS Power Up

Figure 7-2 shows the location of the AC and DC Power breakers on the

Microcell unit. Both the AC and DC breakers must be pushed in to

power up the unit.