Installation Instructions

ATP Overview

DEC 2000

7-1

SCt300 BTS Hardware Installation, ATP and FRU Procedures

PRELIMINARY

Overview

The purpose of this procedure is to outline the optimization and ATP

after a BTS installation. Calibration of the BTS is performed in the

factory and is not required. The ATP is also performed in the factory

and is optional.

All the procedures in this chapter are to be performed with the BTS out

of service or under LMF control. If necessary, refer to the “Shut Down

and Restoring BTS Signaling” procedure in Chapter 7.

For a complete listing of the required tools and equipment, refer to the

“ATP Tools and Equipment” list in Chapter 1.