Installation Instructions

SU Cabling
PRELIMINARY
SCt300 BTS Hardware Installation, ATP and FRU Procedures
DEC 2000
6-44
Objective
The objective of this procedure is to install the SU cable on one or more
units.
Cable Labels
The cable designations are referenced to Table 6-5 in the “Cable
Description” area of this chapter.
Tools and Equipment
Required tools
A 5/16–in. breakaway torque wrench is required to do this procedure.
Motorola parts
SU Distribution Terminators, SMA (Motorola Part Number
0187683C02) are required to do this procedure.
Table 6-30 provides the quantitity and description of the SU cable used
for a single–unit installation.
Table 6-30: Cables Needed for SU Connections
Cable Qty. Part Number Description
P 1 3087416C19 SU cable, 105 mm
Q N/A* 3088120C01 SU RF cable, long (part of kits SGEN4062A, SGEN4061A,
SGEN4064A, SGEN4063A, SGEN4066A, SGEN4065A,
SGEN4068A, SGEN4067A, SGEN4070A and SGEN4069A).
R N/A* 3088120C02 SU RF cable, short (part of kits SGEN4066A and SGEN4065A)
*Quantity of cables depends upon system configuration. Refer to “Motorola Kits for Multi–Unit Installations”
for more information.
Motorola kits
Table 6-31 through Table 6-40 gives the Motorola Kit numbers, cable
descriptions and part numbers for the Motorola kits required to perform
the SU cabling on a multi–unit installation. Several kits are available
depending upon the carrier installation.
Table 6-31: Microcell Expansion Kit for Units 1 to 2 Short MIB A (Cubicle) – T448AL
Cable Qty. Motorola Part
Number
Description
n/a 2 5882106P01 50 Ohm Antenna Terminator
A 1 3087701C02 Ground cable, 8 -AWG, insulated copper wire. Requires one ring lug
connector.
K 1 3087707C09 MIB A cable (short, 1m; micro)
Q 1 3088120C01 Long SU Cable
6