Installation Instructions

MIB Cabling for Multi–Unit Configurations
PRELIMINARY
SCt300 BTS Hardware Installation, ATP and FRU Procedures
DEC 2000
6-38
Overview
The objective of this procedure is to attach the MIB cabling for a
multi–BTS configuration.
Cable Labels
The cable designations are referenced in Table 4–1 in the “Cable
Descriptions” procedure in Chapter 4.
Tools and Equipment
Motorola parts
The following terminators in Table 6-19 are necessary to do this
procedure for a single–unit installation and are shipped with the unit:
Table 6-19: MIB Terminators
Quantity Part Number Description
3 3009865S04 Terminator, MIB (Picocell)
1 3009865S02 Terminator, MIB (Microcell)
2 3009865S04 Terminator, MIB (Microcell)
Motorola kits for multi–unit installations
Table 6-20 through Table 6-29 give the Motorola kit numbers, cable
descriptions and part numbers for the Motorola kits required to perform
a multi–unit installation. Several kits are available depending upon the
carrier installation.
Table 6-20: Microcell Expansion Kit for Units 1 to 2 Short MIB A (Cubicle) – T448AL
Cable Qty. Motorola Part
Number
Description
n/a 2 5882106P01 50 Ohm Antenna Terminator
A 1 3087701C02 Ground cable, 8 -AWG, insulated copper wire. Requires one ring lug
connector.
K 1 3087707C09 MIB A cable (short, 1m; micro)
Q 1 3088120C01 Long SU Cable
6