Installation Instructions

Attaching the Site I/O Junction Box to the Unit – continued

PRELIMINARY

SCt300 BTS Hardware Installation, ATP and FRU Procedures

DEC 2000

6-16

Figure 6-10: Attaching the Site I/O Junction Box to the Unit

SITE I/O JUNCTION BOX

CAPTIVE SCREWS

Procedure to Attach a Site I/O

Cap to the Unit (optional)

Use the following procedure in Table 6-9 to attach a Site I/O Cap to the

unit.

Table 6-9: Procedure to Attach a Site I/O Cap to the Unit (optional)

Step Action

1 Position the Site I/O cap, Motorola Part Number

3888121C01, over the Site I/O socket.

2 Use a T30 Torx tamper bit to tighten (but do not torque) the

upper tamper resistant screw.

3 Tighten but do not torque the lower tamper resistant screw.

4 Use a T30 Torx tamper bit to torque the upper and lower

screw to 5 N–m.