Installation Instructions

Full Unit Replacement Procedures
DEC 2000
9-21
SCt300 BTS Hardware Installation, ATP and FRU Procedures
PRELIMINARY
Objective
The objective of this procedure is to replace a Microcell or Picocell unit.
See Figure 9-7.
System Impact/Considerations
The removal of the failed unit will require system downtime.
Required Tools and Materials
The following tools and materials are required to do this procedure:
Tools
The following tools are required to do this procedure:
S Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M
S T20 TORX Tamper Bit, 1/4–in. hex
S T30 TORX Tamper Bit, 1/4–in. hex
S 13 mm torque wrench set to 5.0 N–M
S 5/16 breakaway torque wrench 9–in. lb.
S 13/16 breakaway torque wrench 38–in. lb
S Key for lock
S Handles for unit (optional)
Replacement units
One Microcell or Picocell unit is required to do this procedure.
Replacement Procedure
Before you begin
Before you begin, enter the following information into the following
replacement list table.
Table 9-13: Item Number Replacement List
Item Description
BTS Number
Failed Unit Number
Remove the failed unit
Follow the steps in Table 9-14 to remove the failed unit.
Table 9-14: Remove the Failed Unit
Step Action
1 Place the BTS out of service. Refer to the “Shut Down Signaling Functions” procedure in
Table 9-2.
2 If necessary, use a T20 TORX Tamper bit to remove the Solar Cover.
. . . continued on next page
9