Installation Instructions

Short Duration Battery Replacement Procedures
PRELIMINARY
SCt300 BTS Hardware Installation, ATP and FRU Procedures
DEC 2000
9-16
Objective
The objective of this procedure is to replace the short duration battery.
Required Tools and Materials
The following tools are required to remove the solar cover and install the
new battery.
Tools
Attaching the battery to the unit requires:
S T20 Torx tamper bit, 1/4–in. hex
S T30 Torx tamper bit, 1/4–in. hex
S Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M
S Two (2) Screws M6x19 (Motorola Part Number 0387541C03)
Replacement units
One Battery – Kit T392AA is necessary for this procedure.
Replacement Procedure
Before you begin
Before you begin, enter the following information into the following
replacement list table.
Table 9-7: Item Number Replacement List
Item Number
BTS number
Failed Battery number
9