Installation Instructions

Shut Down & Restore BTS Signaling – continued
DEC 2000
9-5
SCt300 BTS Hardware Installation, ATP and FRU Procedures
PRELIMINARY
The EDIT SECTOR REDIRECT command does NOT
affect calls in progress and will NOT move these calls to
another sector/carrier. The command only prevents future
calls from being originated on the targeted sector/carrier. If
active call processing is still taking place in the target
sector/carrier, it is advisable to wait for any active calls to
terminate prior to disabling the sector.
IMPORTANT
*
Table 9-2: Shut Down Signaling Functions
Step Action
1 Open a CLI window. Refer to Table 9-1.
2 Determine channel status of the MAWI prior to performing the following step by entering the
following command:
omc–000000>STATUS MAWI–<bts#>–<mawi#> ADD
This command will display the busy overhead channels as well as any busy traffic channels.
3
* IMPORTANT
Record the values shown in the following system display response. These values will be used to
answer the prompts for the EDIT SECTOR REDIRECT command when restoring signaling
operations at the end of the replacement procedure.
View the status of the sector signaling redirect parameters for all carriers equipped for the sector
by entering the following command at the prompt:
000000>DISPLAY SECTOR <bt #> <t#>REDIRECT
omc–000000>DISPLAY SECTOR–<bts#>–<sector#> REDIRECT
Observe the following typical system display response (this example shows initial standard
values):
Access Overload Class Redirect Flags ROTATE
CARRIER ID RETURN 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1 1 TIMER RECORD EXP IGNORE SYS
(bts–sector–carrier) IF FAIL 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 (SEC) TYPE SID CDMA ORDERING
–––––––––––––––––––– ––––––– – – – – – – – – – – – – – – – – ––––– –––– ––– –––– –––––––
CARRIER–1–1–1 N N N N N N N N N N N N N N N N N 4 1 0 N CUSTOM
. . . continued on next page
9