Installation Instructions

Shut Down & Restoring BTS Signaling

PRELIMINARY

SCt300 BTS Hardware Installation, ATP and FRU Procedures

DEC 2000

9-4

Overview

The FRU procedures require the shut down of BTS signalling functions.

Accessing the OMCR CLI

window

The commands to manipulate the BTS in the following replacement

procedure must be entered via UNO or OMCR (Operations and

Maintenance Center – Radio).

Should there be any issues which affect CLI operations or

the UNO/OMCR, this replacement procedure cannot be

performed.

IMPORTANT

Accessing the OMCR CLI window

The commands used in the following replacement procedure in Table 9-1

are entered at the OMCR.

Table 9-1: Login and Access Alarm Window Procedure

Step Action

1 Login by entering the user name.

2 Enter the password at the system prompt.

3 Open an Alarm Manager window and an OMCR CLI window from the pull down menu using the

mouse button.

4 Verify that the filter display is set to ALL. This is so that any alarms which may be encountered

while installing the hardware can be observed and rectified.

Shut Down Signaling Functions

Table 9-2 contains steps for shutting down the signaling functions for the

sector/site.

The BTS acts like a single sector and all sector commands

operate on the BTS carrier.

NOTE