Installation Instructions

Create CAL File

PRELIMINARY

SCt300 BTS Hardware Installation, ATP and FRU Procedures

DEC 2000

8-2

Overview

Use this procedure to create a CAL file for the Calibration audit. You

must do this procedure before the RF path audit.

Create CAL File

The Create CAL File function gets the BLO data from the MAWI and

creates/updates the CAL file for the BTS. If a CAL file does not exist, a

new one is created. If a CAL file already exists, it is updated. The BTS

is calibrated at the factory and normally does not require calibration after

installation, so you must use the Create CAL File function to create a

CAL file since TX calibration is not performed.

The Create CAL File function only applies to selected

(highlighted) MAWIs.

NOTE

The user is not encouraged to edit the CAL file as this

action can cause interface problems between the BTS and

the LMF. To manually edit the CAL file, you must first

logout of the BTS. If you manually edit the CAL file and

then use the Create CAL File function, the edited

information is lost.

NOTE

Prerequisites

You must do the following steps before you run this test:

S The MAWI has the correct code load and data load.

S The MAWI is INS.

S The LMF is logged on to the BTS.