Installation Instructions

Copy LMF CAL File to CBSC – continued
PRELIMINARY
SCt300 BTS Hardware Installation, ATP and FRU Procedures
DEC 2000
7-62
Copying CAL Files from
Diskette to the CBSC
Follow the procedures in Table 7-34 to copy CAL file from a diskette to
the CBSC.
Table 7-34: Copying CAL Files from Diskette to the CBSC
Step Action
1 Log in to the CBSC on the OMC–R Unix workstation using your account name and password.
2 Place your diskette containing calibration file(s) in the workstation diskette drive.
3 Type in eject –q and press the Enter key.
4 Type in mount and press the Enter key.
NOTE
S Check to see that the message floppy/no_name is displayed on the last line.
S If the eject command was previously entered, floppy/no_name will be appended with a
number. Use the explicit floppy/no_name reference displayed.
5 Type in cd /floppy/no_name and press the Enter key.
6 Type in ls –lia and press the Enter key. Verify that the bts–#.cal file is on the diskette.
7 Type in cd and press the Enter key.
8 Type in pwd and press the Enter key. Verify you are in your home directory (/home/<name>).
9 With Solaris versions of Unix, create a Unix–formatted version of the bts–#.cal file in your home
directory by entering the following command:
dos2unix /floppy/no_name/bts–#.cal bts–#.cal and press the Enter key
(where # is BTS number).
NOTE
Other versions of Unix do not support the dos2unix command. In these cases, use the Unix cp
(copy) command. The copied files will contain DOS line feed characters which must be edited out
with a Unix text editor.
10 Type in ls –l *.cal and press the Enter key. Verify the cal files have been copied.
11 Type in eject and press the Enter key.
12 Remove the diskette from the workstation.
7