Installation Instructions

TX & RX Acceptance Tests

DEC 2000

7-53

SCt300 BTS Hardware Installation, ATP and FRU Procedures

PRELIMINARY

TX ATP Test

Refer to Table 7-29 to perform a TX ATP test. This procedure assumes

that the site specific CDF file is in the wlmf\cdma\bts–# folder.

The ALL TX list performs the following ATP tests:

1. TX Mask

2. Rho

3. Pilot Time Offset

4. Code Domain Power

Prerequisites

You must successfully complete all the procedures outlined in previous

chapters before you attempt to run an ATP.

Table 7-29: TX Acceptance Test Outline

Step Action

1 Set up test equipment for TX tests per Figure 7-17 or Figure 7-18.

2 Perform the following to run TX Acceptance Tests:

– Select the MAWI.

– Click on the Tests menu

– Select ALL TX.

* IMPORTANT

The DPLL must be tracking either GPS or HSO.

TX Tests Using Backup

Synchronization (Sites

Equipped With GPS)

Follow the steps in Table 7-30 to perform the TX test using backup

synchronization.

Table 7-30: TX Test Using Backup Synchronization

Step Action

1 If logged into the BTS with the LMF, then logout.

2 Open an MMI Communication session.

3 Verify that the BTS is in OOS_RAM status by entering the status command.

4 Simulate an LMF connection by entering the sndtype 0xa178 command.

. . . continued on next page