Installation Instructions

Attaching Unit to Mounting Bracket
PRELIMINARY
SCt300 BTS Hardware Installation, ATP and FRU Procedures
DEC 2000
6-8
Objective
The objective of this procedure is to attach the unit to the mounting
bracket. This procedure applies to mounting brackets that are attached to
a rack, wall, ceiling or pole. This procedure also applies to both the
MicroCell and PicoCell units.
Background
The unit attaches to the mounting bracket with two (2) M6 screws and
the provided pin or a customer–supplied padlock.
For ceiling mount applications, two people must do this
procedure. One person must steady the unit while the
second person installs the unit.
WARNING
The handles should be mounted to the unit before
mounting the unit to the bracket. The handles should be
used to lift the unit onto the bracket. If the solar cover is to
be used, the back cover must be attached prior to mounting
the unit. Remove the handles once the unit has been
secured to the mounting bracket.
NOTE
Tools and Materials
The following tools and materials are required to attach the unit to the
mounting bracket:
S Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M
S T30 Torx tamper bit
S Two M6X19 screws (Motorola Part Number 0387541C03)
6