Installation Instructions

Test Equipment Setup – continued

PRELIMINARY

SCt300 BTS Hardware Installation, ATP and FRU Procedures

DEC 2000

7-36

Acceptance Test (ATP)

Equipment Setup

Follow the steps outlined in Table 7-21 to set up test equipment prior to

performing ATP tests.

LMF based measurements factor in cable and attenuator

loss between the BTS and test equipment. No additional

attenuation can be inserted as the additional losses would

not be factored in.

IMPORTANT

Table 7-21: Test Equipment Setup

Step Action

1 If you have not already done so, interface the CDMA LMF computer to the BTS and login to the BTS.

2 Refer to NO TAG to set up test equipment.

Verify that the coaxial cable from the appropriate TX connector on the BTS is connected to the test

equipment RF input port via the in line 30 dB high power attenuator for MicroCell BTSs.