Installation Instructions

Attaching Optional Installation Handles to the Unit
PRELIMINARY
SCt300 BTS Hardware Installation, ATP and FRU Procedures
DEC 2000
6-6
Objective
The objective of this procedure is to attach the optional installation
handles to the unit. The location for the handles is shown in Figure 6-5.
The handles should be used when lifting or carrying the unit.
Required Tools and Materials
Tools
Attaching the installation handles to the unit requires:
S T30 Torx tamper bit
S Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M
Motorola parts
Table 6-2 lists the parts necessary to do this procedure.
Table 6-2: Installation Handle Kit – SGLN5754
Quantity Part Number Description
4 387541C03 Screws M6x190
1 0787668C01 Left Handle
1 0787668C02 Right Handle
Procedure to Attach the
Installation Handles to the Unit
Use the procedure in Table 6-3 to attach the installation handles to the
unit. Refer to Figure 6-5.
Table 6-3: Procedure to Attach the Installation Handles to the Unit
Step Action
1 Hold the left handle in position and start the upper screw. The
handles are marked left and right. Refer to Figure 6-5.
2 Position and start the lower screw.
3 Use a T30 Torx tamper bit to torque both screws to 5.0 N–m.
4 Repeat steps 1–3 for the right handle.
6