Installation Instructions

Cable Descriptions
PRELIMINARY
SCt300 BTS Hardware Installation, ATP and FRU Procedures
DEC 2000
4-2
Cable Descriptions and Part
Numbers
Table 4-1 gives the cable descriptions and part numbers for the cables
used to install the BTS. The following cables are necessary for sites
equipped with the customer–supplied Site I/O Interface and the Primary
Surge Suppressor.
Table 4-1: Cable Descriptions and Part Numbers
Cable Qty. Part Number Description
A 1 3087701C02 Ground cable, 8 -AWG, insulated copper wire. Requires one ring lug
connector. Used for Primary Surge Suppressor Installation.
B 1–4 3087701C01 Ground cable. Installed between Site I/O Junction Box and Mounting
Bracket.
C 1–8 Customer
Supplied
Antenna cable, 50–Ohm coaxial terminated with at least one male,
N–type connector.
D 2–6 Customer
Supplied
Antenna cable, terminated with 2 male N–type connectors
E 1* 3087707C03 MIB A cable (current, 2m; micro) (part of kit SGEN4068A,
SGEN4067A and SGEN4061A)
F 1* 3087707C04 MIB B cable (current, 2m) (part of kit SGEN4066A, SGEN4070A
and SGEN4068A)
G 2* 3087707C05 MIB C cable (current, 2m) (part of kit SGEN4070A and
SGEN4068A)
H 1* 3087707C06 MIB A cable (long, 2m; pico) (part of kit SGEN4070A, SGEN4069A
and SGEN4063A)
I 1* 3087707C07 MIB B cable (long, 5m) (part of kit SGEN4065A, SGEN4069A and
SGEN4067A)
J 2* 3087707C08 MIB C cable (long, 5m) (part of kit SGEN4069A and SGEN4067A)
K 1* 3087707C09 MIB A cable (short, 1m; micro) (part of kit SGEN4062A)
L 1* 3087707C10 MIB A cable (short 1m; pico) (part of kit SGEN4064A)
M 1
3086039H11 RGPS cable, 125 ft.
3086039H12 RGPS cable, 250 ft.
3086039H13 RGPS cable, 500 ft.
3086039H14 RGPS cable, 1000 ft.
3086039H15 RGPS cable, 2000 ft.
N 1 Customer
Supplied
Span cable. 22–24 AWG solid copper twisted pair.
. . . continued on next page
4