User's Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsSC4812ETL 1.9GHz CDMA BTS

100

Download the BTS – continued

PRELIMINARY

SC 4812ETL BTS Optimization/ATP

08/15/2000

3-32

Download RAM Code and Data

to MGLI and GLI

Follow the steps outlined in Table 3-13 to download the RAM code and

data to the MGLI and other installed GLI devices.

Release 2.9.x RAM code must NOT be downloaded to a

device loaded with Release 2.8.x ROM code, and Release

2.8.x RAM code must NOT be downloaded to a device

loaded with Release 2.9.x ROM code.

All devices in a BTS must have the same Release–level

ROM and RAM code before the optimization and ATP

procedures can be performed.

If a newly–installed Release 8–equipped BTS is to be

upgraded to Release 2.9.x, the optimization and

Acceptance Test Procedures (ATP) should be accomplished

with the Release 2.8.x code and software. Following the

optimization, the site code and software should be

upgraded to Release 2.9.x by the CBSC. It is not necessary

to perform the optimization and ATPs again after the

upgrade.

If a replacement device with Release 2.8.x ROM code

must be used in a Release 2.9.x–equipped BTS, the device

ROM code can be changed using the CDMA LMF before

the performing the BTS optimization and ATPs. A device

loaded with Release 2.9.x ROM code can not be converted

back to Release 2.8.x ROM code in the field without

Motorola assistance.

CAUTION

Prerequisites

S Prior to performing these procedures, ensure a code file exists for each

of the devices to be loaded.

S The CDMA LMF computer is connected to the BTS (refer to

Table 3-6), and is logged in using the GUI environment (refer to

Table 3-7).

Table 3-13: Download and Enable MGLI and GLI Devices

Step Action

1 From the Util pull down menu, select Tools, then Update NextLoad.

2 Select the correct code version and click Save.

3 Download code to the MGLI by clicking on the device.

4 From the Device pull down menu, select Download Code.

A status report is displayed confirming change in the device(s) status. Click OK to close the status

window. (The MGLI will automatically be downloaded with data and enabled.)

. . . continued on next page