User's Manual

Index – continued
PRELIMINARY
SC 4812ETL BTS Optimization/ATP
08/15/2000Index-6
test cable, 1-9
RF Path Bay Level Offset Calibration, 3-64
RFDS – Fault Isolation, 6-20
RFDS Calibration, 3-82
RFDS Location, SC 4812ET, 1-21
RFDS Test Subscriber Unit, 3-31
RFDS TSU Calibration Channel Frequencies, 3-82
Rho
TX waveform quality acceptance test, 4-12
waveform quality requirements, 4-12
ROM code
described, 3-30
downloading, G-1
ROM code download Caution, 3-32, G-2
ROM code download Warning, G-1
RS232 to GPIB interface
modifications required for Automated Testing, 1-7
required test equipment, 1-7
RX
acceptance tests, FER, 4-18
antenna VSWR, test data sheets, A-11
sensitivity/frame error rate, 4-8
RX and TX paths fail, Troubleshooting, RFDS, 6-20
S
SC 4812 BTS Optimization/ATP Test Matrix, B-4
SCCP Backplane Troubleshooting, Procedure, 6-15
SCCP shelf, 1-18
SCLPA, convergence test data sheets, A-7
Selecting Test Equipment, 3-56
Set Antenna Map Data, 3-80
Set RFDS Configuration Data, 3-81
Setting Cable Loss Values, 3-62
Setting Control Port, 3-5
Setting TX Coupler Loss Value, 3-63
SIF, output considerations vs BBX gain set point, C-1
Site, equipage verification, 3-3
Site checklist, verification data sheets, A-2
Site documents, 1-12
site equippage, CDF file, 3-2
Site expansion, 1-4
Span line
T1/E1 verification equipment, 1-10
troubleshooting, 6-29
Span line configuration, troubleshooting, 6-30
Span Line connector , 6-14
SPANS LED, 6-25
Spectral purity, TX mask – primary and redundant
BBX, 4-7
Spectral purity transmit mask, acceptance test, 4-10
Spectrum analyzer, optional test equipment, 1-10
STATUS LED, GLI, 6-25
Supported Test Sets, 3-47
SYNC Monitor Connector, CSM, 6-24
System Connectivity Test, F-5
T
T1, isolate BTS from the T1 spans, 3-4
Tektronics model 2445 test equipment, 1-10
Telco Interface Board TIB, 1-20
Test data sheets
Alarm verification, A-11
general optimization checklist, A-4
GPS receiver operation, A-5
initial power tests, A-3
LFR receiver operation, A-6
pre–power tests, A-3
preliminary operations, A-2
RX antenna VSWR, A-11
SCLPA convergence, A-7
site checklist, A-2
TX antenna VSWR, A-10
TX BLO, A-8
verification of test equipment used, A-1
Test equipment
See also Optional test equipment; Required test
equipment
set up, TX output verification/control, 4-3
system analyzer, 1-8
TX acceptance tests, 4-3
verification data sheets, A-1
Test equipment connections , F-1