User's Manual

Required Test Equipment and Software – continued
08/15/2000
1-7
SC 4812ETL BTS Optimization/ATP
PRELIMINARY
S Maintenance
S Calibration
S Optimization
Ethernet LAN Transceiver (part of CGDSLMFCOMPAQNOV96)
S PCMCIA Ethernet Adpater + Ethernet UTP Adapter
3COM Model – Etherlink III 3C589B
used with
S Transition Engineering Model E–CX–TBT–03 10BaseT/10Base2
Converter (or equivalent)
Xircom Model PE3–10B2 or its equivalent can also be used
to interface the CDMA LMF Ethernet connection to the
RFM frame.
NOTE
RS–232 to GPIB interface
S National Instruments GPIB–232–CT with Motorola CGDSEDN04X
RS232 serial cable or equivalent; used to interface the CDMA LMF to
the test equipment.
S A standard RS–232 cable can be used with the following
modifications:
–Pin 8 (CTS) does not have to be jumpered/shorted to the others as it
is a driver output. The DTR is already a driver output signal. The
other pins are to receivers. Short pins 7, 1, 4, 6 on each cable end:
9–pin D (female) 9–pin D (female)
GND 5 5 GND
RX 3
3 RXTX 2
2 TX
RTS 7 7 RTS
RSD/DCD 1 1 RSD/DCD
DTR 4 4 DTR
DSR 6 6 DSR
Model SLN2006A MMI interface kit
S Motorola Model TRN9666A null modem board. Connectors on
opposite sides of the board must be used as this performs a null
modem transformation between cables. This board can used for
10–pin to 8–pin, 25–pin to 25–pin, and 10–pin to 10–pin conversions.
S Motorola 30–09786R01 MMI cable or equivalent ; used to interface
the CDMA LMF serial port connection to the GLI, CSM, ETIB board,
and module debug serial ports.
1