User's Manual

RX FER Acceptance Test – continued

08/15/2000

4-19

SC 4812ETL BTS Optimization/ATP

PRELIMINARY

FER Acceptance Test

Follow the steps in Table 4-9 to verify the FER on all RX antenna paths

using all BBXs equipped at the BTS.

Table 4-9: Test FER

Step Action

1 Set up the test equipment for RX acceptance tests per Table 4-1.

2 Select the BBXs and MCCs to be tested.

3 From the Tests menu, select FER.

4 Select the appropriate carrier(s) (carrier-bts#-sector#-carrier#) displayed in the Channels/Carrier pick

list.

NOTE

To select multiple items, hold down the Shift or Ctrl key while making the selections.

5 Enter the appropriate channel number in the Carrier n Channels box.

6 From the RX Branch pick list, select the branch/branches to be tested.

7 Select the desired rate from the Rate Set pick list (1 = 9600, 2 = 14400).

8 Click OK. The status report window is displayed and a Directions pop-up is displayed.

9 Follow the cable connection directions as they are displayed. The test results are displayed in the

status report window.

10 Click Save Results or Dismiss.

NOTE

If Dismiss is used, the test results will not be saved in the test report file.