User Manual

Using CDMA LMF – continued
July 1999
3-21
SC 4812ET BTS Optimization/ATP – CDMA LMF
PRELIMINARY 2
Enabling Devices
Use the Enable menu from the Device menu to place a device in
service (INS). Before a device can be INS, it must be in the
disabled (OOS_RAM) state (yellow) with data downloaded to the
device. The color of the device changes to green, once it is INS.
Prerequisite: Ensure the data has been downloaded to the device.
(1) A CSM device can take up to 20 minutes to enable and
Fail may appear in the P/F column of the Enabling
Devices window. The color of the CSM changes to green
when it is enabled.
(2) Some enabled devices can be either in service
active (INS_ACT) or in service standby (INS_STB).
Bright green indicates that the device is INS_ACT and
dark green indicates that the device is INS_STB.
NOTE
Putting a BBX2 in service keys the BBX2. If the TX is not
properly terminated and if incorrect transceiver parameters
are provided, the BTS can be damaged.
CAUTION
Follow the procedure in Table 3-11 to change the state of device(s) to
Enable.
Table 3-11: Enabling Devices
 Step Action
1 Select the device(s) you wish to enable.
NOTE
The MGLI and CSM must be INS before an MCC can be put INS.
2 Click on Device from the menu bar.
3 Click on Enable from the Device menu. A status report window is displayed.
NOTE
If a BBX2 is selected, a transceiver parameters window is displayed to collect keying information.
Do not enable the BBX2.
4 Click OK to close the status report window.
The selected devices that successfully change to INS change color to green.
3