User Manual

Preparing the LMF – continued

PRELIMINARY 2

SC 4812ET BTS Optimization/ATP – CDMA LMF

July 1999

3-16

Table 3-7: BTS Login Procedure

 ActionStep

3 Click on the desired BTS number.

4 Click on the Network Login tab (if not already in the forefront).

5 Enter correct IP address (normally 128.0.0.2 for a field BTS, if not correctly displayed in the IP

Address box).

6 Type in the correct IP Port number (normally 9216 if not correctly displayed in the IP Port box).

7 Change the Multi-Channel Preselector (from the Multi-Channel Preselector pick list), normally

MPC, corresponding to your BTS configuration, if required.

8 Click on the Use a Tower Top Amplifier, if applicable.

9 Click on Login. (A BTS tab with the BTS is displayed.)

NOTE

 If you attempt to log in to a BTS that is already logged on, all devices will be gray.

 There may be instances where the BTS initiates a log out due to a system error (i.e., a device

failure).

 If the MGLI is OOS_ROM (blue), it will have to be downloaded with code and data, and then

enabled before other devices can be seen.

Logging Out

Follow the procedure in Table 3-8 to logout of a BTS.

Table 3-8: Procedures to Logout of a BTS

 Step Action

1 Click on Select menu.

2 Click on Logout menu item (A Confirm Logout pop-up message will appear).

3 Click on Yes (or press the Enter key) to confirm logout and return to the Login tab.

NOTE

The Select menu on either the BTS tab or the Select menu on the displayed cage/shelf can be

used. In either case you will only be logged out of the displayed BTS.

You may also log out of all BTS login sessions and exit the LMF by using the File –> Exit menu

item. (A Confirm Logout pop–up message will appear.)

Pinging the Processors

If the LMF is unable to login to a BTS, the integrity of the Ethernet

LAN A & B links must be be verified for proper operation. The cell–site

must be powered up first.

. . . continued on next page