User Manual

Preparing the LMF

PRELIMINARY 2

July 1999

3-9

SC 4812ET BTS Optimization/ATP – CDMA LMF

Overview

Software and files for installation and updating of LMF are provided on

CD ROM disks. The following installation items must be available:

 LMF Program on CD ROM

 LMF Binaries on CD ROM

 Configuration Data File (CDF) File for each supported BTS (on

floppy disk or available from the CBSC)

 CBSC File for each supported BTS (on floppy disk or available from

the CBSC)

The section that follows provides information and instructions for

installing and updating LMF software and files.

Update Procedure

Follow the procedure in Table 3-4 to update the LMF program and

binaries.

 Install the LMF program using the LMF CD ROM and follow the

procedure in Table 3-4.

 Install binary files using the LMF CD ROM and follow the procedure

in Table 3-4.

 folders in the wlmf\cdma folder.

 Move applicable CDF and CBSC files into each BTS folder.

Table 3-4: CD ROM Installation

 Step Action

1 Insert the LMF Program CD ROM disk into the LMF CD

ROM drive.

– If the Setup screen is displayed, follow the

instructions provided.

– If the Setup screen is not displayed, proceed to step

2 Click on the Start button.

3 Select Run.

4 Enter d:\autorun in the Open box and click on the OK

button.

(If applicable, replace the letter d with the correct

CD ROM drive letter.)

5 Follow the directions displayed in the Setup screen.