User Manual

Optimization/Calibration – Introduction – continued

PRELIMINARY 2

SC 4812ET BTS Optimization/ATP – CDMA LMF

July 1999

3-2

BTS System Software

Download

BTS system software must be successfully downloaded to the BTS

processor boards before optimization can be performed. BTS operating

code is loaded from the LMF computer terminal. Before you can log

into a site, the LMF must have a BTS folder for that site. Whenever

there is a new release of BTS system software (binaries), it must first be

loaded on the LMF from a CD–ROM before it can be downloaded to the

BTS. The CDF is normally obtained from the CBSC on a floppy disk or

through a file transfer protocol (ftp) if the LMF computer has the

capability.

Site Equipage Verification

If you have not already done so, use an LMF to view the CDF, and

review the site documentation. Verify the site engineering equipage data

in the CDF to the actual site hardware.

Always wear a conductive, high impedance wrist strap

while handling any circuit card/module to prevent damage

by ESD. Extreme care should be taken during the removal

and installation of any card/module. After removal, the

card/module should be placed on a conductive surface or

back into the anti–static bag in which it was shipped.

CAUTION