User Manual

Index – continued
PRELIMINARY 2
SC 4812ET BTS Optimization/ATP – CDMA LMF
July 1999Index-6
BLO test data sheets, A-8, A-13
TX & RX Path Calibration, 3-61
TX and RX Frequency vs Channel , D-3
TX and RX Signal Routing, C–CCP Backplane
Troubleshooting, 5-20
TX Audit Test, 3-69
TX Bay Level Offset and TX ATP test equipment
setup calibration, 3-57
TX Calibration Test, 3-66
TX Code Domain Power ATP, 4-18
tx fine adjust, E-1, E-1
TX Mask Verification, spectrum analyzer display,
illustration, 4-13
TX Output Acceptance Tests – Introduction
Code domain power, 4-10
Pilot time offset, 4-10
Spectral purity TX mask, 4-10
Waveform Quality (rho), 4-10
TX Path Calibration, 3-62
TX Pilot Time Offset ATP, 4-16
TX Spectral Purity Transmit Mask ATP, 4-11
TX VSWR procedure
Advantest Test Set, 3-82
HP Test Set, 3-80
TX Waveform Quality (rho) ATP, 4-14
TX/RX OUT Connections, 4-2
txmask test, 4-11
U
Unshielded Twisted Pair. See UTP
Updating CDMA LMF Files, 3-9, 6-1
UTP
cable (RJ11 connectors), 3-8
LMF to BTS connection, 3-7
V
Verify, test equipment used, test data sheets, A-1
version Folder, 3-13
Voltage Standing Wave Ratio. See VSWR
VSWR
manual test setup detail
Advantest illustration, 3-83
HP illustration, 3-81
measure and calculate RX/TX VSWR for each
antenna
Advantest Test Set, 3-82
HP Test Set, 3-80
required test equipment, 3-79
transmit and receive antenna, 3-79
VSWR Calculation, 3-80, 3-83
VSWR Equation, 3-80, 3-83
W
Walsh channels, 4-18
When to optimize
Ancillary – table, B-1
BTS, B-1
inter–frame cabling, B-2
X
XCVR Backplane Troubleshooting, 5-13
Xircom Model PE3–10B2, LMF to BTS connection,
3-7