User Manual

Optimization Overview – continued

July 1999

1-5

SC 4812ET BTS Optimization/ATP – CDMA LMF

PRELIMINARY 2

optimize the BTS equipment. You can, of course, substitute test

equipment with other test equipment models supported by the local

maintenance facility (LMF) meeting the same technical specifications.

LMF Hardware Requirements

An LMF computer platform that meets the following requirements (or

better) is recommended:

 Notebook computer

 266 MHz (32 bit CPU) Pentium processor

 4 Gbyte internal hard disk drive

 Color display with 1024 x 768 (recommended) or 800 x 600 pixel

resolution

 64 MB RAM

 CD ROM drive

 3 1/2 inch floppy drive

 Serial port (COM 1)

 Parallel port (LPT 1)

 PCMCIA Ethernet interface card (for example, 3COM Etherlink III)

with a 10Base–T–to–coax adapter

 Windows 98/NT operating system

If 800 x 600 pixel resolution is used, the CDMA LMF

window must be maximized after it is displayed.

NOTE

Required Test Equipment

To ensure consistent, reliable, and repeatable optimization test results,

test equipment meeting the following technical criteria should be used to

optimize the BTS equipment. You can, of course, substitute test

equipment with other test equipment models supported by the LMF

meeting the same technical specifications.

During manual testing, you can substitute test equipment

with other test equipment models not supported by the

LMF, but those models must meet the same technical

specifications.

NOTE

The customer has the responsibility of accounting for any measurement

variances and/or additional losses/inaccuracies that can be introduced

as a result of these substitutions. Before beginning optimization or

troubleshooting, make sure that the test equipment needed is on hand

and operating properly.