User Manual

Appendix B: FRU Optimization/ATP Test Matrix – continued
PRELIMINARY 2
SC 4812ET BTS Optimization/ATP – CDMA LMF
July 1999
B-4
Table B-3: SC 4812ET BTS Optimization and ATP Test Matrix
Doc
Tbl
#
Description
Directional Coupler (RX)
Directional Coupler (TX)
RX Filter
RX Cables
TX Cables
Multicoupler/Preselector
CIO
C–CCP Backplane BBX2 MCC24/MCC8E
CSM
LFR/HSO
GPS
GLI2
LPA
LPA Filter Bandpass
Power Converters (See Note)
SWITCH CARD
LPA Combiner Filter 2:1 LPA Combiner Filter 4:1
LPA Backplane
Table 2-1
Initial Boards/Modules
Install, Preliminary
Operations, CDF Site
Equipage; etc.
                    
Table 2-18
DC Power Pre-Test
 
Table 2-3
Initial Power-up
 
Table 3-7
Start LMF Session
     
Table 3-16
Download Code
 
Table 3-18
Enable CSMs
 
Table 3-21
GPS Initialization /
Verification
  
Table 3-22
LFR Initialization /
Verification
 
Table 3-36
TX Path Calibration
  
Table 3-37
Download Offsets to
BBX2
  
Table 3-38
TX Path Calibration Audit
          
Table 4–5
Spectral Purity TX Mask
ATP
       
Table 4–6
Waveform Quality (rho)
ATP
         
Table 4–7
Pilot Time Offset ATP
         
Table 4–8
Code Domain Power /
Noise Floor
  
Table 4–9
FER Test
    
NOTE
Replace power converters one card at a time so that power to the C–CCP shelf is not lost. If power to the
shelf is lost, all cards in the shelf must be downloaded again.
B