User Manual

Module Front Panel LED Indicators and Connectors – continued

July 1999

5-25

SC 4812ET BTS Optimization/ATP – CDMA LMF

PRELIMINARY 2

GLI2 Pushbuttons and

Connectors

RESET Pushbutton – Depressing the RESET pushbutton causes a

partial reset of the CPU and a reset of all board devices. GLI2 will be

placed in the OOS_ROM state

MMI Connector – The RS–232MMI port connector is intended to be

used primarily in the development or factory environment but may be

used in the field for debug/maintenance purposes.

LAN Connectors (A & B) – The two 10BASE2 Ethernet circuit board

mounted BNC connectors are located on the bottom front edge of the

GLI2; one for each LAN interface, A & B. Ethernet cabling is connected

to tee connectors fastened to these BNC connectors.

Figure 5-2: GLI2 Front Panel

MMI PORT

CONNECTOR

ACTIVE LED

STATUS RESET ALARM SPANS MASTER MMI ACTIVE

STATUS LED

RESET

PUSHBUTTON

ALARM LED

SPANS LED

MASTER LED

GLI2 FRONT PANEL