User Manual

Automated Acceptance Test Procedure – All–inclusive TX & RX – continued

PRELIMINARY 2

SC 4812ET BTS Optimization/ATP – CDMA LMF

July 1999

4-6

All TX/RX Test

The LMF Tests menu list item, All TX/RX, performs all transmit and

receive tests for a BBX2(s) and MCC(s). All measurements are made

through the appropriate TX and RX output connectors using the

calibrated TX and RX cable setups.

Prerequisites

Before attempting to run any ATP tests, ensure the following have been

completed:

 CSMs, GLI2s, BBX2s, and MCCs have correct code load and data

load

 Primary CSM, GLI2, and MCCs are INS

 BTS has been Optimized/Calibrated per Chapters 2 and 3

 BBX2s are OOS–RAM

 Test equipment is connected for ATP tests (see Figure 3-16 through

Figure 3-19).

 Test equipment is warmed up 60 minutes and calibrated

 Test cables are calibrated

 GPIB is on

 LMF is logged into the BTS