User Manual

Automated Acceptance Test Procedure – All-Inclusive TX & RX – continued

July 1999

4-5

SC 4812ET BTS Optimization/ATP – CDMA LMF

PRELIMINARY 2

Table 4-2: All RX Acceptance Test

 Step Action

 WARNING

Be very careful to not connect an RX test cable to a TX connector. Failure to observe this

warning may cause bodily injury and/or equipment damage.

1 Select the BBX2(s) and MCC(s) to be tested.

2 From the Tests menu, select All RX

3 Select the appropriate carrier(s) (carrier – bts# –sector# –carrier#) displayed in the

Channels/Carrier pick list (use the Shift or Ctrl keyboard key to select multiple items).

4 Type the appropriate channel number in the Carrier n Channels box.

5 Select the appropriate receive branch (antenna) in the RX Branch pick list. Valid choices are

Main, Diversity or Both.

6 Select the baud rate in the Rate Set pick list.

1=9600 bps

2=14400bps

Click OK.

7 Follow the cable connection directions as they are displayed.

8 Click OK to close the status report window.