User Manual

Automated Acceptance Test Procedure – All–inclusive TX & RX – continued

PRELIMINARY 2

SC 4812ET BTS Optimization/ATP – CDMA LMF

July 1999

4-4

All-RX ATP Test

The CDMA LMF Tests menu list item, All RX, performs all receive

tests for a BBX2(s) and MCC(s). All measurements are made through

the appropriate RX output connector using the calibrated RX cable

setup.

Refer to Table 4-2 to perform an all-inclusive RX ATP test on selected

devices.

Prerequisites

Before attempting to run any ATP tests, ensure the following have been

completed:

 CSMs, GLI2s, BBX2s, and MCCs have correct code load and data

load

 Primary CSM, GLI2, and MCCs are INS

 BTS has been Optimized/Calibrated

 BBX2s are OOS–RAM

 Test equipment is connected for ATP tests (see Figure 3-16 through

Figure 3-19).

 Test equipment is warmed up 60 minutes and calibrated

 Test cables are calibrated

 GPIB is on

 LMF is logged into the BTS