User Manual

Automated Acceptance Test Procedure – All-Inclusive TX & RX – continued

July 1999

4-3

SC 4812ET BTS Optimization/ATP – CDMA LMF

PRELIMINARY 2

Prerequisites

Before attempting to run any ATP tests, ensure the following have been

completed:

 CSMs, GLI2s, BBX2s, and MCCs have correct code load and data

load

 Primary CSM, GLI2, and MCCs are INS

 BTS has been Optimized/Calibrated

 BBX2s are OOS–RAM

 Test equipment is connected for ATP tests (see Figure 3-16 through

Figure 3-19).

 Test equipment is warmed up 60 minutes and calibrated

 Test cables are calibrated

 GPIB is on

 LMF is logged into the BTS

Table 4-1: All TX Acceptance Test

 Step Action

1 Select the BBX2(s) and MCC(s) to be tested.

2 From the Tests menu, select All TX

3 Select the appropriate carrier(s) (carrier – bts# – sector# – carrier#) displayed in the

Channels/Carrier pick list (use the Shift or Ctrl keyboard key to select multiple items).

4 Type the appropriate channel number in the Carrier n Channels box.

5 Click OK.

6 Follow the cable connection directions as they are displayed.

7 Click OK to close the status report window.