User Manual

Transmit & Receive Antenna VSWR – continued
July 1999
3-81
SC 4812ET BTS Optimization/ATP – CDMA LMF
PRELIMINARY 2
Table 3-46: VSWR Measurement Procedure – HP 8921 Test Set
Step HP TEST SETAction
5 If the readings indicate a potential problem, verify the physical integrity of all cables (including any
in–line components, pads, etc.) and associated connections up to the antenna. If problem still persists,
consult antenna OEM documentation for additional performance verification tests or replacement
information.
6 Repeat steps 1 through 5 for all remaining TX sectors/antennas.
7 Repeat steps 1 through 5 for all remaining RX sectors/antennas.
Figure 3-25: Manual VSWR Test Setup Using HP8921 Test Set
RF OUT
ONLY
PORT
RF
IN/OUT
PORT
RVS
(REFLECTED)
PORT
FEED LINE TO
ANTENNA
UNDER TEST
RF
SHORT
30 DB
DIRECTIONAL
COUPLER
OUTPUT
PORT
FWD (INCIDENT) PORT
50–OHM TERMINATED
LOAD
INPUT
PORT
3