User Manual

1X UBS Macro B T S FRU P ack et B T S start -up procedures
Procedure 3 -3 R estore site signaling oper ations procedure for a pack et B T S
(Continued)
8
This step edits the value of the Global Service Redirection Flag ( GLOBALREDIRECT )
in the congestion control parameters so that the Global Service Redirect Message
is only broadcast on the sector paging channel when there is traffic congestion
in the sector
Enter the following command at the prompt using the applicable BTS number:
omc-000000> EDIT BTS-<bts#> CONGESTCONF !
9
The system prompts to enter each control parameter value one at a time. Skip through the
prompts until reaching the following, and enter the parameter shown:
<globalredirect> DISABLE
(This will revert the Global Service Redirect Message to congestion control.)
10
When the system displays the values of the control parameters and the following prompt,
verify that only the GLOBALREDIRECT value changed.
omc-000000>Accept [yes/no]?
11
If only the GLOBALREDIRECT value changed, enter Y to accept the change.
(Now the Global Service Redirection Message will only be sent over the sector paging
channels when there is traffic congestion in the sector .)
12
V erify that the CONGESTCONF globalredirect is disabled for each carrier at the BTS by
entering the following command at the prompt:
omc-000000> DISPLAY BTS-<bts#> CONGESTCONF
13
Display the status of the signaling REDIRECT parameters for all carriers equipped for the
applicable BTS by entering the following command at the prompt:
omc-000000> DISPLAY BTS-<bts#> REDIRECT
14
Examine the values in the system display response to be sure they match the values input in
step 5 of Procedure 3-2 .
Continued
68P09283A64 -3 3 -11
FOA SEP 2007