User Manual

1X UBS Macro B T S FRU Accessing OMCR CLI window
Accessing OMCR CLI window
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Accessing OMCR CLI window
Many of the FRU procedures require the OMCR operator to manipulate BTS logical devices.
This is achieved using UNO or the OMCR (Operations and Maintenance Center - R adio)
Command Line Interface (CLI).
The operator enters commands using UNO or OMCR CLI.
The command dependent replacement procedures cannot be performed, if there are
any issues affecting the UNO or the OMCR CLI operations.
OMCR CLI access procedure
The following procedure is performed by the OMCR operator at the OMCR terminal.
Procedure 3 -1 Login and access alarm window procedure
1
Login to the OMCR by entering the user name.
2
Enter the password at the system prompt.
3
Type CLI at the system prompt to open an OMCR CLI window .
4
Open an UNO Alarm Manager (AM) window by performing the following:
1. Login to UNO as unoadmin
2. Set the env variable DISPLA Y to the IP address of the port where UNO
windows should be run.
3. Type uno & . The main UNO window that was set previously should
appear on the display .
4. Choose icon alarm manager from the main
uno window and set the appropriate filter
– OR –
choose Command Center icon -> BTS SDevices -> right click on
wanted bts icon and choose AlarmManager (filter will be set for
selected bts alarms).
5
V erify that the filter display is set to the BTS -# where the work is being
performed. This ensures that any BTS -# alarms, encountered while
installing the hardware, can be observed and rectified.
68P09283A64 -3 3 -3
FOA SEP 2007