Specifications

1X UBS Macro B T S Optimization/A TP Introduction to Calibr ation
1. Use the status function and verify that all of the installed devices of the following types
respond with status information: HDModem and DMI.
2. V erify the code load of all the devices.
3. V erify the operation of the GPS and QHSO or MSO signals.
4. Unlock the following devices:
UBS
5. Connect the required test equipment for a full optimization.
6. Select the test equipment.
7. P erform the TX Audit.
8. If the TX Audit fails, there is a hardware problem, correct the problem that caused the
failure and repeat the optimization for the failed path.
9. If the TX Audit portion of the optimization passes for the RF path, but some of the TX or
RX tests fail, correct the problem that caused the failure and run the individual tests as
required until all TX and RX tests have passed for all the paths.
68P09283A63 -5 E -3
A UG 2007 FOA