Specifications

V erif ying and Setting GPIB Addresses – Agilent 8935 Series E6380 T est Set Appendix D: T est Equipment Prepar ation
Verifying and Setting GPIB Addresses – Agilent 8935
Series E6380 Test Set
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Figure D -7 Setting Agilent 8935 T est Set GPIB Address
ti-cdma-00122.eps
FW00885
Preset
Cursor Control
Shift
Inst Config
Local
This procedure assumes that the test equipment is set up and ready for testing.
Refer to Figure D -7 when performing the following.
Procedure D -6 V erif y and Set/Change Agilent 8935 Series E6380 T est Set GPIB
Address
1
The HP I/O configuration MUST be set to T alk & Listen, or NO device on
the GPIB bus will be accessible. (Consult test equipment manufacturer’s
documentation for additional information as required.)
D -14 68P09283A63 -5
FOA A UG 2007