Specifications

1X UBS Macro B T S Optimization/A TP V erif ying and Setting GPIB Addresses – Adv antest R3267 Spectrum Analyz er
Verifying and Setting GPIB Addresses – Advantest
R3267 Spectrum Analyzer
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Figure D -5 Setting Adv antest R3267 GPIB Address
ti-cdma-00120.eps
o
n
REMOTE LED
LCL Key
CONFIG Key
Softkey Lable
Display Area
Softkey
Buttons
Keypad BS Key ENTR Key
ti-CDMA-WP-00083-v01-ildoc-ftw
Refer to Figure D -5 when performing the following.
Procedure D -5 V erif y and Set/Change Adv antest R3267 GPIB Address
1
If the REMOTE LED is lighted, press the LCL key .
Result:
• The LED extinguishes.
2
Press the CONFIG key .
Result:
• The CONFIG softkey labels will appear in the softkey label display area of the
instrument display .
• The current GPIB address will be displayed below the GPIB Address softkey label.
3
If the current GPIB address is not set to 18 , perform the following to change it:
1. Press the GPIB Address softkey .
Result: A GPIB Address entry window will open in the instrument display showing the
current GPIB address.
68P09283A63 -5 D -11
A UG 2007 FOA