Specifications

T est Equipment Prepar ation Appendix D: T est Equipment Prepar ation
Test Equipment Preparation
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
This section provides pre–testing set–up information for test equipment supported by the LMF .
Purpose
Pretesting set–up information covered includes verification and setting GPIB addresses,
inter–unit cabling, connectivity testing, pre–test control settings, and equipment calibration for
items which are not calibrated with the Calibrate T est Equipment function of the LMF .
GPIB addresses
This appendix provides information on verification and changing GPIB addresses for the
following test equipment items:
• Agilent E7495A/B test equipment set–up
• Agilent E4406A transmitter test set
• Agilent E4432B signal generator
• Advantest R3267 spectrum analyzer
• Advantest R3562 signal generator
• Agilent 8935 analyzer (formerly HP 8935)
• Advantest R3465 analyzer
• Gigatronics 8541C power meter
• Agilent E4418 power meter
• GPIB adapter
Calibration actions
The following calibration–related subjects are also covered for the test equipment items
indicated:
Cable calibration set -up – Calibrating T est Cable Set–up using Advantest R3465
D -2 68P09283A63 -5
FOA A UG 2007