Specifications

1X UBS Macro B T S Optimization/A TP RX Fr ame Error R ate (FER) Acceptance T est

RX Frame Error Rate (FER) Acceptance Test

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■

■

FER Test

This test veriﬁes the UBS FER on all trafﬁc channel elements is currently conﬁgured (full

rate at 1% FER) at an RF input level of -123 dBm. All tests are performed using the external

calibrated test set as the signal source controlled by the same command. All measurements

are via the LMF .

The sector -carrier is enabled, using only rﬂvl level offsets, to generate a CDMA carrier (with

pilot channel element only). Sector -carrier power output is set to +27.5 dBm as measured at the

TX OUT connector . The UBS must be keyed to enable the RX receive circuitry .

The LMF prompts the CE under test to measure all zero long code and provide the FER report

on the selected reverse link for both the main and diversity RX antenna paths, verifying that

results meet the following speciﬁcation:

• FER returned <1% @ –123 dBm and total frames measured is 1500

All CEs selected are tested on the speciﬁed RX antenna path. See Procedure 4 -6 to perform

this test.

68P09283A63 -5 4 -23

FOA A UG 2007