Product Card

Acceptance T est Procedures - TX & RX Chapter 4: Acceptance T est Procedures
1
Set up the test equipment for abbreviated tests per Procedure 4-3
2
Select the device(s) to be tested.
T o select multiple items, hold down the Shift or Ctrl key while
making the selections.
F or all TX tests except Code domain, a SectorCarrier must be
selected. F or code domain select the modem and carrier . F or RX
test — FER select the modem and SectorCarrier . F or RX test —
RS SI select SectorCarrier only .
3
Click on T ests in the UBS Menu bar , and select All TX/RX A TP ... from
pull-down menu.
4
Select the appropriate SectorCarrier (carrier-bts#-sector#-carrier#)
displayed in the Channels/Carrier pick list.
Since the UBS supports OMNI configurations only , sector# will
always be 1.
5
V erify that the correct channel number for the selected
SectorCarrier is shown in the Carrier # Channels box.
If not obtain the latest bts-#.necf files.
If necessary , the correct number may be manually entered into
the Carrier # Channels box.
6
Select the appropriate RX Branch ( Both,
Main, or Diversity ) from the drop-down menu.
In the R ate Set box, select the appropriate data rate (1=9600, 2= 14400, 3 =
9600 1X) from the drop-down list.
7
In the T est P attern box, select the Standard test pattern from the drop
down list in the Bay Level Offset Calibration section.
8
Click on the OK button.
The status report window and a Directions pop-up are displayed.
9
F ollow the cable connection directions as they are displayed.
The test results are displayed in the status report window .
Continued
4 -10 68P09283A63 -5
FOA A UG 2007