Product Card

Acceptance T est Procedures - TX & RX Chapter 4: Acceptance T est Procedures
Acceptance Test Procedures - TX & RX
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Reduced and Full ATP
The full A TP (all the A TP tests) is optional. It is recommended that the reduced A TP be used.
The reduced A TP consists of TX Audit and Receive Signal Strength Indicator (RS SI).
TX Audit and RSSI Tests
TX Audit The Audit is a power out test that will pass within +/ -2 dB of the expected power .
The standard pattern per S -C is 43dBm and the Audit test will pass if the output power is
within the limits listed above.
TX Audit T est Procedure P erform the procedure in Procedure 4 -1 for TX Audit.
Procedure 4 -1 Procedure for TX A udit
1
Set up test equipment for TX acceptance tests per Figure 3-23 through
Figure 3-26
2
If it has not already been done, configure the test equipment for TX path
audit as in Figure 3-23
3
Click on the devices to be tested.
4
Click T ests > TX > TX Audit
5
Select the appropriate carrier in the Channels/Carrier pick list.
Enter the channel number in the Carrier # Channels box.
T o select multiple items, hold down the Shift or CTRL key while
making the selections.
6
Click OK . The status report window is displayed and then a Directions
pop-up is displayed.
7
F ollow the cable connection directions as they are displayed. T est results are
displayed in the status report window .
Continued
4 -4 68P09283A63 -5
FOA A UG 2007