Manual

P ack et B T S shutdown procedures Chapter 3: R eference Procedures P erformed A t OMCR
Procedure 3 -2 Shutdown site signaling functions procedure for a pack et B T S
(Continued)
(Use the Network ID the subscriber units should expect to find on the system they are
being redirected to .)
expecting an integer number (from 0 to 2047)
<chan1= ?>, <chan2= ?> . . . <chan15= ?>
(A list of CDMA channels for neighbor sites that the subscriber units can use for redirection.)
expecting an enumerated value:
CDMA1900 CDMA2100 CDMA800 CDMA900 JAPANCDMA
<BANDCLASS= ?>
(Use CDMA1900 for 1900 MHz systems, CDMA2100 for 2100 MHz systems, and CDMA800
for 800 MHz systems. This example uses 1900 MHz.)
13
A fter all parameters are entered, the system displays the command to be sent and the prompt
below . V erify the command syntax is correct.
omc-000000>Accept [yes/no]
14
A t the prompt shown in step 13 , enter Y to accept the command or N to go bottom and
enter the correct value(s).
15
Enter the following command at the prompt to display the status of the BTS signaling
REDIRECT2 parameters to verify that the BTS is ready for maintenance:
omc-000000> DISPLAY BTS-<bts#> REDIRECT2
16
Ensure that the values in the system display response match the values input in step 12 .
17
Enter the following command at the prompt to display the existing congestion control
parameters for all carriers equipped for the BTS:
omc-000000> DISPLAY BTS-<bts#> CONGESTCONF
18
This step edits the value of the Global Service Redirection Flag ( GLOBALREDIRECT )
in the congestion control parameters so that the Global Service Redirect Message
is broadcast on all of the sector paging channels at the BTS .
Enter the following command at the prompt using the applicable BTS number:
omc-000000> EDIT BTS-<bts#> CONGESTCONF!
Continued
3 -8 68P09283A64 -3
FOA SEP 2007