Installation Manual
T ools and materials Chapter 1: Introduction and Fr ame Identication
Tools and materials
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Required tools and materials
The following tools and materials are required to perform the installation:
• Battery driver , capable of 3.95 N -m to 5.09 N -m (35 -45 in -lb) torque
• T20 and T25 TORX bits with 12 inch extension
• T orque drivers; 1 N -m, 2.3 N -m, 4.8 N -m +/ - 10%
• 8 mm SMA connector torque wrench; 1.02 N -m (9 in -lb) +/ - 10%
• 19 mm N -type connector torque wrench; 4.3 N -m (38 in -lb) +/ - 10%
• Phillips screwdriver
• Flat screwdriver
• 3/8 -inch ratchet -5.6 N -m (50 in -lb)
• 8 -mm socket
• 19 -mm socket
• 10 -mm deep set socket
• 9/16 -inch socket
• 3/16 -inch socket
• Side cutters
• Dust mask
• Safety glasses
• Ear plugs
• Marker for marking outline on floor
• T ape measure with millimeter scale, capable measuring up to 1200 mm or with inch scale,
capable measuring up to 48 inches
• Shop vacuum
• Cable tie -wraps
• Scissors or knife
• 0.25 W SMA -type terminators for any unused directional port connectors on an
IDRF - customer supplied
1 -16 68P09283A62 -3
PRELIMINARY A UG 2007