Installation Instructions

1X UBS Macro B T S FRU XMI (T r ansceiv er Module Internal) Module

XMI Installation Procedure

F ollow the steps in Procedure 7 -2 to install the XMI.

Procedure 7 -2 XMI Installation Procedure

A T THE BTS SITE

The XMI module is hea vy . T wo people are required to lift, carry , or handle the

XMI module.

• Be sure the remo v able XMI handle is attached to the front of the XMI before

ph ysically handling the module.

• Be sure two people use both hands and wear protectiv e footwear when

handling the XMI.

• Be sure to use two people to support the module while sliding the module

out of or into the shelf slot.

An XMI module that is not in a shelf should alw a ys be set on its side and nev er on

its edge. This will prev ent the XMI module from tipping o v er and causing damage

or injury .

The replacement XMI module should already have the removal handle attached.

If handle

is not

attached, go to step 2 .

If handle is attached, go to step 3 .

A ttach the removable XMI handle to the front of the replacement XMI module (see Figure 1-9

800 MHz XMI Module Front P anel I/O Detail on page 1- 38 or Figure 1-10 1.9 GHz XMI

Module Front P anel I/O Detail on page 1- 39 for location of XMI handle mounting screw

holes) as follows:

• Align handle screw holes with handle mounting screw holes on the XMI front panel.

(Note handle orientation; handle is not symmetrical.)

• Insert two M5 screws.

• Using a T25 TORX driver , tighten the screws to 3.2-3.6 N-m (28-32 in-lb).

Continued

68P09283A64 -3 7 -19

FOA SEP 2007