User Manual

R equired T est Equipment and Softw are Chapter 1: Introduction

Test Set Calibration Support Items

The

Anritsu

MT8212B requires the following additional items to perform the indicated

calibrations:

• F or standard Open -Short -Load (OSL) calibration:

Anritsu

22N50 Open/Short, DC to 18 GHz, N(m) connector , 50 ohm

Anritsu

SM/PL precision load, DC -to -4 GHz, 42 dB, N(m) connector , 50 ohm

• F or standard InstaCal™ calibration:

Anritsu

ICN50

InstaCal

calibration module, 2 MHz to 4 GHz, N(m) connector , 50 ohm

Optional Test Equipment

Not all optional equipment speciﬁed here will be supported by the LMF in automated

tests or when executing various measure type command line interface (CLI)

commands. It is meant to serve as a list of additional equipment that might be

required during maintenance and troubleshooting operations.

High Stability 10 MHz Rubidium Standard

Stanford Research Systems SR625 or equivalent – required for Quartz High Stability Oscillator

(QHSO) frequency veriﬁcation.

Spectrum Analyzer

• Spectrum Analyzer (HP8594E with CDMA personality card) or equivalent; required for

manual tests.

Oscilloscope

• T ektronics Model 2445 or equivalent; for waveform viewing, timing, and measurements or

during general troubleshooting procedure.

1 -12 68P09283A63 -5

FOA A UG 2007