User Manual

Scope and La y out Chapter 1: Introduction

Scope and Layout

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■

■

Scope

The procedures in this manual require the use of Local Maintenance F acilit y (LMF)

application softw are v ersion 2.20.x.x or later .

This publication provides information pertaining to the optimization, calibration, and acceptance

testing of the UBS Macro . Throughout the manual UBS Macro will be referred to as UBS .

The equipment shown in many of the ﬁgures is typical. The actual appearance may

vary slightly .

Assumptions

This document assumes that the UBS and cabling have been installed according to the following

manuals:

•

Frame Mounting Guide; 68P09226A18

, which covers the physical

bolt down

of all

equipment frames.

•

1X UBS Macro BTS Hardware Installation; 68P09283A62

, which covers installation and

cabling conﬁgurations for the UBS Macro .

Audience

Motorola has attempted to incorporate into this document the many customer suggestions and

comments received. Additionally , an attempt has been made to ensure that the scope of the

document supports both the novice and expert site technician and engineer with the information

required to successfully perform the task at hand. If , in some areas, the manual seems to cover

a subject with too much or not enough detail, please keep this in mind.

1 -2 68P09283A63 -5

FOA A UG 2007