User's Manual

Index
68P09258A31–A
1X SCt 4812T BTS Optimization/ATP
Oct 2003
Index-8
Site checklist, data sheets, A-3
Site equipage, CDF/NECF, 3-3
Site I/O board, T1 span cable connection, 5-9
Site Serial Number Check List, A-19
Software Release caveats, 5-2
Span Framing Format
configure, 5-6
verify, 5-5
Span I/O board
E1 span isolation, illustration, 3-15
T1 span isolation, illustration, 3-15
Span Line
connector , 6-14
T1/E1 Verification Equipment, 1-11
Span line, troubleshooting, 6-29
Span line configuration, troubleshooting, 6-32
Span line traffic, No or missing, 6-17
SPANS LED, GLI2, 6-24
Spectral Purity TX Mask, 4-7
Spectrum Analyzer, 1-11, 3-82
Spectrum Analyzer , HP8594E, 3-57
STATUS LED, GLI2, 6-24
SYNC Monitor Connector, CSM, 6-23
System Connectivity Test, HP8921A, F-18
T
T1
isolate BTS from the T1 spans, 3-15
span connection, 5-9
terminal communication settings, J-3
Test data sheets
AMR CDI Alarm Input Verification, A-18
BTS redundancy/alarm tests, A-17
general optimization checklist, A-5
GPS receiver operation, A-6
initial power tests, A-4
LFR receiver operation, A-7
LPA
convergence, A-9
IM Reduction, A-8
pre–power tests, A-4
preliminary operations, A-3
RX antenna VSWR, A-18
site checklist, A-3
TX antenna VSWR, A-17
TX BLO
Offset/Power Output Verification, A-10
Power Output Verification, A-15
Test Equipment
Automatically Selecting, 3-77
Calibrating, 3-78
Connecting test equipment to the BTS, 3-56
Manually Selecting, 3-76
Reference Chart, 3-58
Selecting, 3-75
verification data sheets, A-2
VSWR, I-2
Test equipment
system analyzer, 1-9
TX acceptance tests, 4-6
Test Equipment Setup, 3-56
GPS & LFR/HSO, 3-46
HP PCS Interface, F-23
RF path calibration, 3-89
Test Matrix, C-4
ATP optimization, C-3
Timing Reference Cables, 1-10
Top Interconnect Plate, 1-21