User's Manual

Entering or Changing Router FE Interface IP Address68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-75
Entering or Changing Router FE Interface IP Address
It may be necessary to enter or change the IP addresses and/or operating
parameters for BTS router FE interfaces FE 0 and FE1 without making
other changes in the router configuration files. Procedures in this section
cover these operations.
Prerequisites
The following must be accomplished before entering or changing BTS
router FE port IP addresses and/or operating parameters:
S The user has read and understands the content of MWR1941 Wireless
Mobile Edge Router Software Configuration Guide; part number
78–13983–01
S BTS routers must have the required version of the IOS saved on their
installed CF memory card
S BTS routers must have power applied, be operating without alarms
other than span alarms, and have completed boot–up to the user EXEC
mode prompt (
BTSRTR–bts#–1–1>)
S The BTS router privileged EXEC mode password has been obtained
from the network administrator
Entering or Changing FE Interface IP Addresses
To enter or change FE interface IP addresses, follow the procedure in
Table J-17.
Table J-17: Enter/Change BTS Router FE Interface IP Addresses & Operating Parameters
Step Action
* IMPORTANT
This procedure does not cover all aspects of BTS router operation and programming. Before performing this
procedure, review BTS router initialization, operation, and programming information and procedures in
MWR1941 Wireless Mobile Edge Router Software Configuration Guide; part number 78–13983–01. Have this
publication available for reference while performing this procedure.
1 Obtain the correct IP addresses and subnet masks for the BTS router FE interfaces from the network
administrator.
2 If a HyperTerminal connection for BTS card/module MMI or BTS router (BTSRTR) communication
has not been created, create one as described in Table J-1 of this appendix.
3 Connect the LMF computer to the BTS router, and start a communication session as described in
Table J-2 in this appendix.
. . . continued on next page
J